Grounds remain connected when set to the “GND” position. In the “in” position (the center of the switch changes to orange) both output connectors provide a balanced 150W ? isolated signal that is attenuated by 6dB from the input.Įach of these switches disconnects the ground between the inputs and the XLR outputs when set to the LIFT position.
In the “out” position, the DIRECT OUT/SPLIT 2 provides a direct output signal and the ISOLATED OUT/SPLIT 1 provides a balanced 600W isolated signal. This push-button switch selects the output mode of the unit. The ISOLATED OUT/SPLIT 1 is always transformer isolated and the DIRECT OUT/SPLIT 2 is either directly connected to the input or transformer isolated, depending on the position of the OUTPUT SELECT switch. The male XLR output connectors can be configured in one of two ways. On the Line Balancer/Splitter are two male XLR jacks, one female XLR jack, a ¼” jack, and three switches as outlined below.Įither of the two input connectors, a female XLR jack or a ¼” TRS jack (Tip = Pin 2 and Ring = Pin 3) can be used for connection from a line level source, balanced or unbalanced. The Line Balancer/Splitter uses Whirlwind’s TRSP-600L transformer and has a frequency response of 20 Hz to 20 kHz, ☑ dB +2O dBm. Get A High Quality Addition For Your System With The Whirlwind IMP 2 Direct Box Built rugged on the inside and outside, this is the world famous DI found in.
A choice of two output configurations is provided: one direct output and one isolated output, or two isolated outputs. The Whirlwind Line Balancer/Splitter is designed to split a single line-level input signal into two balanced line-level outputs.
0 kommentar(er)
